No Cost to RequestWritten EstimatesBoulevard Rules ExplainedCascade County Homes

What's Left After the Tree

Stump Grinding in Great Falls, MT

Request a free on-site estimate.

The Tree's Gone. Now the Stump.

Finish the Job Below the Ground

Every removal leaves a stump, and around Great Falls, Montana it tends to outlast whatever plan there was for it. It catches the mower deck, throws cottonwood or boxelder sprouts by June, and after a few springs of wet snow and thaw it is soft, hollow and full of ants. Electric City Tree Co. books stump grinding below grade so the spot can be seeded, fenced or poured over.

Booked with a removal, the stump goes in the same visit, under one price. A stump someone left years ago is fine too: one request and we set up a quick Great Falls estimate.

Request an Estimate

Where We Work

Serving Cascade County and Nearby

Also Malmstrom Air Force Base housing, Floweree, Raynesford, Geyser and the acreages along the Sun River road. See all the areas we serve →

What's Included

Stumps From the Same Removal

Book the grind with the removal and the stump goes that afternoon: one trip, one number. If you would rather see how the yard settles, it can be cut low and ground later.

Old Stumps Somebody Else Left

The boulevard elm cut to a stool and never finished, the cottonwood taken to knee height when the house sold, the row a storm crew left after the February 2020 windstorm. An old stump is often softer, but ash and ponderosa stay hard for years, so the price follows the stump as it is.

Cottonwood, Elm & Other Stumps of Central Montana

A river-bottom cottonwood grinds fast but can measure five or six feet at the flare. Boxelder and Siberian elm run shallow roots across the lawn. A bark-on elm stump must be debarked or destroyed under 8.52.060, because the beetle that spreads Dutch elm disease overwinters there. Green ash is dense and slow; spruce, ponderosa and juniper grind clean.

Surface Roots & Deep Grinds

A usual grind takes the wood 4 to 6 inches under the lawn, deep enough to reseed. For a fence post, a shed pad or a driveway, or to get boxelder roots out of the mowing line, the grind goes deeper and chases the roots, priced as its own line.

A stump grinder wheel cutting into a stump in a lawn, wood chips flying
A close-up of fresh wood chips and stump grindings
A wide cut stump left in a mowed lawn, before grinding

Cost Planning

What You'll Likely Pay for Stump Grinding

JobTypical cost range
Single stump (by diameter)$100–$400
Each additional stump$50–$150
Surface-root chasing / deep grind$75–$200 extra

Ranges are typical for central Montana based on published industry cost guides; your written estimate reflects your specific tree and site. Stump diameter at the flare sets most of the number.

Diameter drives the price, measured at the ground including the flare, so a cottonwood that reads 30 inches across the cut can be 50 where the teeth work. Species, buried lines, the route through the gate and the stump count also move it. Tack it onto a removal and the each-additional-stump rate applies.

Get a Free Estimate

What Grinding Gets You

What's Under the Yard

Bench clay grinds easily dry or frozen; river-bottom cobble toward Black Eagle eats teeth. Older yards hide sprinkler lines a hand's width under the sod, and acreages toward Vaughn, Ulm and Fort Shaw hide irrigation pipe. The pro should ask, probe, and call Montana 811 before every grind.

Ask About Coverage

A grinder throws chips hard and far. It should run with the guards down, and the tree company should carry liability coverage for your siding, windows and the neighbor's pickup; ask for the certificate at the Great Falls estimate.

Upfront Pricing

Diameter, species and depth are settled at the estimate. The figure on the sheet is what you pay, whether the stump takes twenty minutes or two hours and a new set of teeth.

A Clean Finish, Every Time

The hole gets backfilled, the spot raked for seed and the grindings hauled if asked. The City will not take stumps, burning is banned in town (8.8.170), and a log pile left lying is an 8.52 nuisance. Elm leaves under the 8.52.090 permit.

How It Works

Step by Step

Get a Free Estimate

Questions People Ask

Can I just leave the stump?

You can, but cottonwood, boxelder and Siberian elm stumps sprout for years, and a bark-on elm stump is a Dutch elm disease reservoir the code says to debark or destroy. For a quick read, try our Tree Diagnosis tool.

What happens to the grindings?

Your choice. Most people have them backfilled and mounded a little high, since chips and clay settle through a freeze-thaw season. Otherwise they get hauled; chips do not belong at the curb or in the alley.

Can a stump close to my house or fence be ground?

Usually. The grinder works within inches of a post, walk or foundation, with the chip guard toward the house. Septic, well, gas and water lines get located first. A stump in the strip by the street is the City's, and injuring anything there without authority is unlawful (12.14.030), so it gets cleared with Park and Recreation before grinding.

Goes Hand in Hand With

Let's Grind It Out

Have a stump in the way? Request a free estimate.

Are We Close By?

Type your town or ZIP, say Belt or 59405, and see whether we cover it.